![]() ![]() It will load the virtual serial port for the USB interface on your computer or USB drive. This file contains a Support Note and installation program. ![]() In the Downloads section, download the file called Windows7 USB Installer to your computer. The simplest way to install the virtual serial port for the USB interface to the receiver is to go to the Trimble Support website ( and search for the AG-342 receiver. In the Downloads section, download the file called Windows7 USB Installer to your computer or USB drive. The simplest way to install the Virtual Serial port for the USB interface to the SPS receivers is to go to the Trimble Support website ( and search for the SPS GNSS receiver you have. The receiver must be running firmware version 4.15 or later. The other end of the USB cable then connects to a computer. The SPS985 smart antenna has USB cable P/N 80751‐HH that can be connected to the receiver. The SPS modular receivers have a number of USB cables to use. It is possible to use the USB interface from a Trimble AG-342 receiver with a software application that requires a serial port.įor example, the Trimble WinFlash utility can be run on a computer that has no physical serial port by connecting the USB cable between the computer and the receiver.Īnother example would allow the receiver to stream NMEA messages over a USB interface into a computer's virtual serial port, allowing applications such as HYDROpro™ construction software to use the NMEA messages on a computer that has no physical serial ports. ![]() It is possible to use the USB interface from an SPS GNSS receiver with a software application that requires a serial port. Getting Started Guides > SPS985 > Activation > Configuring a PC USB port as a virtual serial port Configuring a PC USB port as a virtual serial port ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |